Im new to this site. Im working with QH and tried data logging my first run on my 347 turbo but im not getting RPM ACT ECT or TP. How is my engine running if the computer is not getting a signal from any of these?

There's a few possibilities to check:

• Make sure the Mode in BE is setup correctly. If it is set to Mode0, you are still running the stock tune and you CANNOT get access to RPM, ACT, ECT, and a few other key parameters without having a real tune in the QH for technical reasons.
• You selected those parameters but haven't rewritten the tune to include those parameters. Some datalogging options are "part" of the tune. So if the EEC isn't running your tune or your tune doesn't contain them, you won't receive them.
• You are receiving them, but they aren't getting saved as what you expect, so you are missing them.

There are probably other possibilities, but those are the ones I could think to check in just a few seconds.

_________________
...Always Somethin'

89 Ranger Supercab, 331 w/GT40p heads, ported Explorer lower, Crane Powermax 2020 cam, 1.6RRs, FMS Explorer (GT40p) headers, Slot Style MAF, aftermarket T5 'Z-Spec', 8.8" rear w/3.27s, Powertrax Locker, Innovate LC-1, GUFB, Moates QuarterHorse tuned using BE&EA

Member V8-Ranger.com

Thanks...i will make the adjustments tomorrow. I am pretty excited about getting the car dialed in. Any help is much appreciated!