Just wondering since this one is better

1. Make sure that you have Caledit running
2. On the input/output make sure the "data logging" is checked in the Tweecer box.
3. Hit the "Start Logging" and "Log to file".
4. Start your car.

This is what works for me.

Yea that's one of the settings that I changed, I lowered it to "0".
Is that to low?
It seems to work ok for me at that setting.

I think I might have fixed it. I looked at my MAF transfer graph and noticed that it looked like something was wrong so I made a few changes, disconnected my battery to clear the codes, started up fine, idled fine, drove around for a couple of miles with no problems at all, check engine light never ...

I didn't data log yet but I will.....how would I post a data log?

When I let my car warm up to about 150* it starts to get a very bad surging idle followed with a "check engine" signal. If I step on the gas it goes away. If I drive the car it runs fine until I take my foot of the gas and the idle drops to about 1000 I get the check engine signal again and the roug...

:( to bad I wanted CalEdit to show my name when I opened it up

See above