[1gcrazy]

I’ve already desoldered an EECIV chip off the board and curious how I can backup the chip? Assuming these are eproms(not eeproms), what’s the process to uv erase one of these for reflashed? I’m certain if this is possible it’s already been done but I tried searching but the server load is too high(please try again later) so here I am.

[jsa]

The usual process is to leave the prom soldered to the EEC and use DCL if it has it, or use a QH and BE or TP to read out the prom.

The prom is not usually reflashed, but instead a QH or J3 chip is used to serve the binary to the EEC.

The UVPROM can be erased using a UV light source for a period of time.

Writing the UVPROM, requires finding the correct hardware and software. Not so easy and dearer than current methods mentioned above.