[rl]

OK, I sent my LPT Tweecer to get fixed per Mikes recommendation. I got it back and I'm still having issues.

Using the only j3.dll file that will work, bi-di port settings, and the latest LHBLO file I still cannot read the EEC. It says invalid or unsupported binary image. When I try to write to the EEC from a good C3P2.bin file (from Raymond) it completes the write, then the motor runs fine, however the automatic trans does not. The OD light stays on and the trans stays in limp mode.

Is there ANY fix for this?

FYI, this is on a 94 Lightning C3P2 computer.

Rob