Innovate LMA-3 Sensor setup Binary Editor

This is the place for questions about things electrical and mechnanical...or any other automotive-related hardware issue.

Moderators: cgrey8, EDS50, Jon 94GT, 2Shaker

Post Reply
dwbro1
Gear Head
Posts: 17
Joined: Mon Nov 16, 2015 1:07 am

Innovate LMA-3 Sensor setup Binary Editor

Post by dwbro1 » Sat Oct 08, 2016 12:00 pm

I have the Innovate DLG-1 and LMA-3 in my Mustang with BE.

My DLG-1 WBs are data logging just fine in BE but nothing else. :( I know it has to be how they are setup in BE just a little confusing to me. Here is what I have

1. My WBs are fine logging into BE on channels 0 and 1.

2. I have RPM in channel 3 which isn't recording

3. Channel 4 is lateral G (nothing logging)

4. channel 5 I have EGT sensor in passenger side header that won't record.

5. channel 7 is forward G

6. channel 6 is MAP sensor ( I have inline with Boost guage nada recording)

7. channel 8 NONE

Any help would be appreciated. I've read over the BE instructions and cannot quite figure it out
Moates QH | DLG-1 WBO2 & LMA-3 | B50 block | CHP 347 (8.5:1) | Canfield Stage 3 Heads | Cam (284/294) | 1.6 roller rockers | Hydraulic Lifters | Canton Oil pan | Kenne Bell 1.5L (5 lbs Boost) | GT40 Lower | 75mm TB | Pro-M 75mm | 36lb Injectors | EEC-Tuner | MSD 6AL | Aluminum Driveshaft | 373:1 Gears | 9mm wires | Aero Fuel Pump (300 lph) | McLeod RST Clutch | Tremec TKO 500 | QuickTime Bellhousing | Wilwood Brakes | KB AGS Level 5 | Koni Reds | CC Plates | Springs | Flaming River steering shaft

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests