ECC IV Chip Case

This is the place for questions about things electrical and mechnanical...or any other automotive-related hardware issue.

Moderators: cgrey8, EDS50, Jon 94GT, 2Shaker

Post Reply
kmplace
Gear Head
Posts: 2
Joined: Wed Dec 13, 2017 3:39 pm
Location: Sidney Ohio

ECC IV Chip Case

Post by kmplace » Thu Dec 14, 2017 8:22 am

I have made this case to go on the End of the computer to protect my moates OH, would anyone have any interest in these? i could provide the STL file and you can take to local 3D print shop or i could possible make a few
Attachments
Moates Lid.jpg
Moates Lid.jpg (28.51 KiB) Viewed 392 times
ecc case.JPG
ecc case.JPG (121.96 KiB) Viewed 393 times
1993 SSP Mustang, 302,GT40 Heads, Downs upper, LJMS Custom turbo cam, BW S366 turbo, A9L QH:BE

motorhead1991
Regular
Posts: 83
Joined: Tue Nov 21, 2017 2:32 am

Re: ECC IV Chip Case

Post by motorhead1991 » Thu Dec 14, 2017 11:52 am

Might even fit the early EEC-Vs. I know my FLH2 (EEC-V) had a similar sized hole as my M0M2 (EEC-IV)
1990 Ford Ranger FLH2 conversion. Ford forged/dished pistons, Total Seal file-fit rings, Clevite rod and main bearings, Clevite cam bearings, IHI turbo, Siemens Deka 60lb/hr injectors, Ford slot MAF in custom 3" housing. Moates Quarterhorse with Binary Editor, using the PAAD6 database.

OpenEEC Telegram Chat:
Telegram

ironmanisanemic
Regular
Posts: 175
Joined: Tue May 24, 2011 8:33 pm
Location: Vandenberg AFB, CA

Re: ECC IV Chip Case

Post by ironmanisanemic » Fri Dec 15, 2017 11:52 am

I'd be interested in the model. There are a few different case designs that I've seen for the ecus but the same piece should be able to be tweaked to fit them all.
1989 Ford Bronco:
-393W, Edelbrock Performer RPM heads, ProComp Upper and lower intake, Custom Comp Hyd Roller cam, 10:1 compression, 30lb injectors, 75mm TB, Pro-M 80mm MAF, equal length short tube headers, 2.5 inch y pipe merged into single 3 inch with hooker aerochamber muffler and no cat, QH w/ BE and EA running U4P0, AOD

1995 Ford Mustang GT
-Bone stock minus the QH. 5 Speed. T4M0

Tun3r
Gear Head
Posts: 7
Joined: Wed Apr 04, 2018 6:36 am

Re: ECC IV Chip Case

Post by Tun3r » Tue Apr 10, 2018 11:55 pm

you've done a great job on that one

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests