[genghis117]

Hi Everyone, I hope all is going well. I need some assistance in obtaining a spark table for use with my tuning project. Here are the specifics of my project. I have installed a 351W (roller-cam block) in my 1989 LTD Crown Vic. I had this engine re-built from scratch. It was over-bored by 0.030. I kept the original cast iron heads and also found a 2V cast iron intake (with the EGR spacer-plate). The cam utilized is a standard roller cam (specifically a Melling SYB-51), nothing crazy. I also have the engine mated to Ford's AOD transmission and a shift kit is installed. I am expecting 180 to 190 HP out of the engine as I did not do any mods for significant HP increases (mainly due to the C-clip rear axle).

I need a spark table for the setup I have described in the paragraph above. I have read postings on this site that seem to reference a library of spark tables, however I can't seem to find anything. Please let me know where I might find a table or if you have access to the tables and can direct me, please let me know.

Thanks in advance for your assistance.

-Andy