HP calc

BinaryEditor and EEC Analyzer are both packed with awesome features, but if you can think of another cool feature to aide in EEC Tuning or some improvement to an existing feature, cough it up here.

Moderators: cgrey8, EDS50, Jon 94GT, 2Shaker, 86GT

Post Reply
tvsn94
Regular
Posts: 85
Joined: Sun Oct 10, 2010 5:40 pm
Location: Appling Ga

HP calc

Post by tvsn94 » Tue Feb 12, 2013 10:58 pm

Clint, My last pull showed 643 HP @ 609lb on the BE data log.
I really don't believe it, what are the variables? and are they changable to give a more accurate result.
94 Cobra,stock cam w/1.7 rockers,forged internals neutral balance 9-1 comp. ported lower intake 70 mm HP single turbo kit @ 9 lb , blowing through full mufflers, 05 slot HPX 3"tube blow through, Glenns Performance 1000HP system w/ twin 255 Walbros, 60 lb Siemens injectors, Mcloed street twin, TKO 600 tranny(shifts terrible), 3.08 gear ,T4MO.BEB from Pops Racing w/ quarter horse, BE/EA, AEM wide band, and boost gauge.MSD6, Qdata , ECT

decipha

Re: HP calc

Post by decipha » Tue Feb 12, 2013 11:22 pm

bsfc

that and your maf curve

remember its engine hp

User avatar
86GT
BE/EA Developer
Posts: 5080
Joined: Sat Feb 22, 2003 11:19 pm
Location: Dixon, California
Contact:

Re: HP calc

Post by 86GT » Sun Dec 22, 2013 11:29 am

Yes change the BSFC to lower the number. Again the HP/TQ is only for reference. You would really need to be on a dyno and then adjust the BSFC to match what the dyno had. From that point forward the BSFC should be good until you change fueling parameters.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest