LC-2 WB Binary editor connection issues

Anything about Ford EEC tuning. TwEECer and Moates questions dominate, but there's some SCT and OBD-II knowledge too.

Moderators: cgrey8, EDS50, Jon 94GT, 2Shaker

Post Reply
Balthorpe
Gear Head
Posts: 17
Joined: Fri Mar 03, 2017 9:25 am

LC-2 WB Binary editor connection issues

Post by Balthorpe » Wed May 24, 2017 4:28 pm

Can someone walk me through this setup... I have the lc-2 wide band w/ gauge. I can't seem to log AFR in binary editor. The gauge and logworks both show AFR. Binary editor recognizes innovate hardware when its plugged in to the usb. I tried to click the enable button in the hardware section...then i couldn't data log anything. I guess it's some kinda port issue...

Anyone with the lc-2 that can help me out i appreciate it..
'93 f250 xlt 2wd. 351w, E4od. speed density T2X1 code, EFI-SD48B. S.Bob LHBL0 cry. ICY1
BBk 61mm T body, edel 3881 truck intake, AFR 185, H. Roller 216/220 @.050 .533/.544 lift 114 LSA
1 5/8" long tubes, dual 2 1/2, Borla pro xs. Local cruising, occasional tow
Innovate LC-2 Wb

Post Reply

Who is online

Users browsing this forum: No registered users and 26 guests