Unable to select any payload variables

Jon E · Post by **Jon E** » Fri May 02, 2003 9:50 pm

1.)
When I go to the utilities tab to select the payload variables to datalog the payload button is greyed out (i.e. it does not work) and I cant check any of the boxes.

2.)
When I first start caledit everything works fine. I can read /write program and everything. After about 1-2 min when I go back to try to read EEC or read tweecer it gives the message "unable to open tweecer" and sometimes it gives the message "corrupt or unsupported binary" etc.

What am I doing wrong????

94GTLaserRC · Post by **94GTLaserRC** » Sat May 03, 2003 8:17 pm

I would first start by uninstalling the programs, then reinstalling. That should only take a couple of minutes. Make sure the ignition is powered on, but engine not running, when going through TwEECer checks.

RC

Jon E · Post by **Jon E** » Sun May 04, 2003 10:31 am

Which tweecer checks do you mean?

desmo996 · Post by **desmo996** » Sun May 04, 2003 11:47 am

1st thing we need to know is are you using 1.20b3 of the TwEECer software? And what EEC calibration you are working with?

Jon E · Post by **Jon E** » Sun May 04, 2003 9:35 pm

Im using version 1.19 with an A9L and the A9LPL binary.

When I first open cal edit it gives the prompt "DAT file corrupt" and then after caledit opens it then gives another prompt saying "invalid or unsupported Binary image"

Do I need to download the new version?

Post by **Jon 94GT** » Tue May 06, 2003 10:24 am

Jon E wrote:Im using version 1.19 with an A9L and the A9LPL binary.

...

Do I need to download the new version?

You just answered your own question :). Download 1.20B3 and all your problems should disappear.

Jon E · Post by **Jon E** » Tue May 06, 2003 4:23 pm

Ok I can do that. But shouldnt it have worked anyway with the old version?

Post by **Jon 94GT** » Tue May 06, 2003 6:49 pm

Versions prior to 1.20 did not have dynamic payload capability, so no, what you are seeing is what you are supposed to :).

Jon E · Post by **Jon E** » Wed May 07, 2003 8:25 pm

Thanks Jon. That fixed it!

Unable to select any payload variables

Who is online