While keying in values into a new calibration file I noticed that CalEdit refuses to save/retain changes to the Injector Slope High scalar (new value = 30). It however accepted changes to Injector Slope High=36 and Checksum base address = 0.
Thinking it was expecting a floating point value I tried 30.1 and that too didn't work.
GJ
UPDATE:------------ Question answered on the Yahoo list. -----------
I need to press <Enter> after keying the value. Mouse-clicking to another field will not work.
It would appear that the Yahoo site still gets better results (quicker replies).
GJ
Moderators: EDS50, cgrey8, 2Shaker, Jon 94GT
CalEdit refuses to accept Injector Slope High value
G.Baylon
Toronto, CANADA
95GT, AODe, J4J1, 1.30A9
75mm Pro-M 30# cal, 30# injectors
Cobra Intake, 65mm TB, GT-40 alum heads
190 l/hr fuel pump, FRPP headers
FRPP Supercharger
Toronto, CANADA
95GT, AODe, J4J1, 1.30A9
75mm Pro-M 30# cal, 30# injectors
Cobra Intake, 65mm TB, GT-40 alum heads
190 l/hr fuel pump, FRPP headers
FRPP Supercharger
Who is online
Users browsing this forum: No registered users and 20 guests