Anything about Ford EEC tuning. TwEECer and Moates questions dominate, but there's some SCT and OBD-II knowledge too.
1 post • Page 1 of 1
im new to these ECU's and i've been trying to figure out how to disable 2 evap faults and set readiness. evap faults are P0443 and P0453. i have searched high and low for a tuner pro XDF with no luck. this is in a ranger that is swapped from a 3.0 to a 4.0 V6 from an explorer. also there is an issue with the wheel speed on the cluster being off, im not sure if that can be calibrated in the ECU or if thats a sensor issue. i have attached the stock 256k full read BIN. i hope someone can help. thanks.
- Explorer LEZ2 full bin
- (256 KiB) Downloaded 24 times
Who is online
Users browsing this forum: No registered users and 27 guests