binary editor hardware not found

This is the place for questions about things electrical and mechnanical...or any other automotive-related hardware issue.

Moderators: cgrey8, EDS50, Jon 94GT, 2Shaker

Post Reply
Tuner2019
Gear Head
Posts: 2
Joined: Sun Jun 23, 2019 9:43 am

binary editor hardware not found

Post by Tuner2019 » Sun Jun 23, 2019 9:50 am

The hardware is seen by TunerPRO but not binary editor. it is licensed. Havent used it yet.
To confirm it is not the chip or computer the fuel pump does constantly run with key on and The computer does make a notification noise as well as say it is using com5 for the USB. I tried com3 but no change in results.

Tuner2019
Gear Head
Posts: 2
Joined: Sun Jun 23, 2019 9:43 am

Re: binary editor hardware not found

Post by Tuner2019 » Mon Jun 24, 2019 4:21 pm

Got it reading now.
It was a driver issue. Uses a different driver than TunerPRO .

motorhead1991
Regular
Posts: 149
Joined: Tue Nov 21, 2017 2:32 am

Re: binary editor hardware not found

Post by motorhead1991 » Mon Jun 24, 2019 5:06 pm

I believe TPRT can use the BE driver but not vice-versa. I switch between the two all the time.
1990 Ford Ranger FLH2 conversion. Ford forged/dished pistons, Total Seal file-fit rings, Clevite rod and main bearings, Clevite cam bearings, IHI turbo, Siemens Deka 60lb/hr injectors, Ford slot MAF in custom 3" housing. Moates Quarterhorse with Binary Editor, using the PAAD6 database.

OpenEEC Telegram Chat:
Telegram

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests