[Kurt]

Hey everyone. I'm reaching out to the forum members here looking for the last release of BE2010 (build 40). I recently transferred my BE2010 to a new PC with the help of Clint. Unfortunately I realized after the transfer that my BE2010 install that I had kept was only of build 6 and I need at least build 38. I asked Clint for the last build but he said that he no longer has BE2010. He said that he would look for a backup of it. So, I thought perhaps I could reach out to someone here who may have a copy on hand and save Clint the trouble of digging through his backups for it. recklessford at gmail.com

[decipha]

40 sucks, you don't want anything past 32

[Kurt]

decipha to the rescue again.

Thank you.

[sailorbob]

If you are using BE 2010 then you should be using build 41.

[Kurt]

If you are using BE 2010 then you should be using build 41.

Would you happen to have a copy?

[sailorbob]

Email sent.

[Kurt]

Both of you have sent me the .exe and they both work in terms of BE starts up as the appropriate build number. But, whenever i plug in my QH I get the error in the attached pic.

I only get it when using the .exe's that were sent me. However, it works fine with the build 6 .exe

I have done an uninstall reinstall of both BE and the FTD drivers (ftd clean) I also got the latest version of the ftd drivers. no change.

Again, BE recognises the QH just fine when used with the executable that it was installed with. Any suggestions?

[ashford]

can i get the link to be2010 as well i currently have update 40. derek when i bought a def from you last year the installer linked in my email was corrupted or bad, it would not run in win 7 or xp just come up then close in a few seconds. has this been fixed since then?