[Kingfish999]

my Quarterhorse had a soldered on battery that i tired to replace in the past. i ended up breaking the tabs so i soldered wires in the spot and put it to the new battery. i guess when messing with the Quarterhorse yesterday, one of the wires broke free so my tune keeps blanking. i went to repair it tonight but now i broke off both wires and unsure which side was positive and negative. can soemone tell me which of these is positive and negative? ignore the RTV everywhere

[decipha]

the two posts on the side edge are positive the single central post is negative

heres some photos

http://forum.efidynotuning.com/viewtopi ... =21&t=2221

[Kingfish999]

i couldn't view the pics but i soldered and it up alot better this time and shouldn't be an issue ever again. hopefully its right guess ill find out tomorrow when i put the tune on it. appreciate it

[Kingfish999]

grrrr.... its still not working. i must have overheated the 2 points i soldered because they dont have continuity to any other points. i tried tried again in another spot and with my meter shows good this time. i love soldering but not stuff this small. if it doesnt work this time ill probably jsut buy a new quarterhorse. in Binary Editor it shows v1.6 but on the board shows v1.3. not sure if it was updated before but it may be a reason i had issues with datalongging

[decipha]

you can send it in to moates and theyll fix it for you for free