[rl]

OK, I just got my TwEECer back, went to use it, it doesn't read the EEC (invalid or unsupported binary image), but it writes to the tweecer OK, idle changes work etc.

The problem I am having is with the transmission. The OD light stays on and the tranny goes into some kind of a limp mode. I've tried everything I can think of, 2 different c3p2 .BIN's, but I dont have any clue what is causing this...

What do I need to do to make it work?

Also, how do I get numbers next to the graphs? like ROM vs. Timing shows no numbers on the X or Y axis, just in the graph.

I'm using a LPT twEECer that was just repaired, a good c3p2.bin and the newer LHBLO.dat with caledit 1.18.

Rob

[rl]

Any ideas?

Mike?

[rl]

Nothing?