Newbie to Tweecer?

StangCrazy · Post by **StangCrazy** » Thu Dec 19, 2002 11:04 pm

I don't even know where to start and how to get programs that I can program the computer. Please give me some guidance.

MAYHEM1 · Post by **MAYHEM1** » Sat Dec 21, 2002 10:50 pm

go to tweecer.com and go to downloads and download all the files available, put the files where they are routed to the usually go to program files under stkr folder and then open the caledit file and start changing parameters, but i will tell u have alot of problems with the files and i myself have no idea where to start

StangCrazy · Post by **StangCrazy** » Sun Dec 22, 2002 9:40 pm

How do you get to the Caledit file because I can not find it. It the first download all I need or do I need to do the RT one.

black sunshine · Post by **black sunshine** » Sun Dec 29, 2002 10:44 am

http://www.tweecer.com/downloads.html
download the full Rt setup, and when you get it, it will be the install for both Calcon and Caledit.

StangCrazy · Post by **StangCrazy** » Thu Jan 02, 2003 10:02 pm

Which will I use to program the car the caledit or the calcon or do you use both. Thanks

93notch · Post by **93notch** » Fri Jan 03, 2003 12:35 am

CalEdit is the interface to make changes to the calibration data and CalCon gives you feedback on what you have changed. You cannot write to the tweecer while CalCon is open so you must close it to access the tweecer with CalEdit. You can keep Caledit open and still use CalCon though.

StangCrazy · Post by **StangCrazy** » Fri Jan 03, 2003 12:34 pm

Thanks for your help.

Newbie to Tweecer?

new tweecer user

Who is online